Swan-Neck Brass Banded Bail Pull in Antique-by-Hand - 3 1/2-Inch Center-to-Center

I was refinishing a 1940s era walnut desk; a massive 6 foot by 3 foot top, eight drawers, and three slide-out typewriter tables. It was all original, except was missing some handles. Not only did the reproduction bail pulls work, they worked with the old rosettes! The desk project is finished now and waiting for a buyer.I am very pleased with the look of the hardware; you can't tell the old from the new.

I inheirited my parents dresser but it was missing two bails. These matched very well although the screws were too short and the round part was slightly smaller than the originals. You can't tell the difference unless you know they are different.

I was missing a pull knob off of this Morganton China Hutch. I found the House of Antique Hardware site and found the pull knob that was needed to finish this beautiful Hutch. [...] I will use this company again to find the hardware that I I will need for the restoration work I do for my business. Thanks

The handles were of good quality and the color was nice although they didn't have it in the color I needed. I can refinish the color myself. Also the medallion backing each end was smaller than my original but fortunately, I had the old medallions and was able to change them out. Worked out really well in spite of the differences. I was so happy to find a replacement so close to the originals.

There is always room for improvement.

Very well finished. Helpful staff. Replacement pulls for bedroom furniture.

The only thing that should be included in the discription is the DIAMETER of the ROSETTES. These are ONE (1)inch, Mine measure 1 and 7/64"" - a noticable difference since I only replace the ONE that was broken, of SIX.