2 1/4" Cast Brass Label Holder & Pull With Choice of Finish

I am using these for a dresser filled with my sewing supplies. I can tell at a glance what is in each drawer. One of the pulls broke but I think I over-tightened the screws when installing.

I love it!

As a professional writer and furniture restorer, I am reluctant to accept anything less than near perfect in the materials that I choose to complete a project. The brass pulls and label holders that I ordered from the ""House of Antique Hardware"" far exceeded my expectations. I was surprised at the workmanship and the grade of the materials. I would recommend ""The House of Antique Hardware"" to anyone who believes in putting the best into a furniture project.

Bought these for a card catalogue style cabinet for nails and screws. The handles are excellently made, good finish, consistent. Install easily and the card slot for labels is adequate width to easily fit cards made from cut up index card stock.

This is a fantastic, hard-to-find product. Advertised ""At only 1"" high"" I thought these would be perfect for my ~1-1/8"" tall toolbox drawers. But the 1"" doesn't include the drop of the pull. Fortunately they are solid brass and so I was able to trim off the drop and polish them up.

I bought 13 of these label holder/pulls to install on an antique oak filing cabinet. The cabinet already had old label holder/pulls on 20 other drawers. The oil-rubbed finish was attractive and went well (although not perfectly) with the old pulls already in place. My only concern was the limited size selection. I had to settle for new pulls that were close, but a bit smaller than the old hardware. On balance, though, these pulls are a good value for the money and look nice on the drawers.

Bought the brushed nickel finished but it came with chrome screws.

The pulls are nice. The screws are cheap and tough to put in hickory without a perfect sized hole.

The label holder finish and design was exactly as pictured and expected. I had to replace many of the screws because the heads stripped even with a predrilled pilot hole.

I used these on new magazine files I made. They look great and the finger pull makes accessing each file so easy.