Classic Offset Drawer Pull - 3" Center to Center

3 Reviews

Your Selection:

Select Your Finish:

 
$21.99 - $22.89
Quantity discounts available
QuantityPrice
Item #: R-08BM-1346X

Description

Our Classic Offset Drawer Pull (3-Inch Center-to-Center) was a favorite in the early 20th-century. The simple, comfortable design is useful on kitchen cabinets, built-ins and even window sashes. Made of solid, cast brass in three period finishes.

Overall dimensions: 3 5/8" L x 13/16" H x 7/8" P. Center to center: 3".

Hardware Tip

Center-to-center is the measurement between mounting holes. It is also referred to as the on center measurement or C-C. The C-C may vary, measure before drilling.
WARNING: California Proposition 65
Back

Ratings & Reviews

3 reviews

  • 5 stars
  • 1 reviews
  • 4 stars
  • 2 reviews
  • 3 stars
  • 0 reviews
  • 2 stars
  • 0 reviews
  • 1 star
  • 0 reviews
Write a Review

Beautiful, weighty, classic pull

Comments:

We're painting the cabinets in our newly purchased home, and switching out all the hardware from builder-grade brushed nickel to classic styles in polished nickel. I ordered two different pulls from HOAH to test which would work/look best using the existing 3"" screw holes. This pull was the winner because the screws are the same size and install from inside the drawer, just like the existing pulls. It's a little pricier than I wanted to spend, but classic, tailored and beautiful!

Was this review helpful?

Classic brass cabinet door and drawer pulls

Comments:

I really like my classic brass drawer and door cabinet pulls. We sprayed a coat of clear lacquer on them to keep the shine as long as possible, although I am not sure it was necessary. They look good and work great. However, the matching brass screws were not quite long enough for the thickness of the drawers and needed substitutions for those screws.

Was this review helpful?

nice but small

Comments:

I ordered one as a sample and it is very nicely made but too small for the project. I will keep it as a sample for future projects where a small pull is desired.

Was this review helpful?